breaking length
英 [ˈbreɪkɪŋ leŋθ]
美 [ˈbreɪkɪŋ leŋθ]
断裂长度，切断长度
双语例句
- Breaking strength: The quality of paper by specifying its breaking length in metre.
裂断强度：以纸张的裂断长（米）来表达纸张品质。 - The main factors which affect the shrinkage of regular acrylic top are the steam pressure and speed of stretch-breaking machine, breaking length of fibre and recut separation distance of top mixing gill box, in which the steam pressure plays the most important role.
探讨了影响腈纶正规条缩率的主要因素，如拉断机汽蒸压力、车速、拉断长度、混条机再割隔距，其中拉断机汽蒸压力对正规条缩率影响最大。 - Breaking length of ice sheet against sloping structure
冰排与斜面结构作用时的破断长度分析 - The following determinations were made on the initial and aged samples: MIT folding endurance, internal tearing resistance, bursting strength, breaking length, brightness, copper number and average degree of polymerization.
纸张老化前后测试的性能为MIT耐折度、撕裂度、耐破度、裂断长、白度、铜价和聚合度。 - The paper brightness, breaking length, pulp drainage and filler retention are improved but tear index decreases when the additive is used.
加助剂后，纸页的白度、滤水性能、填料留着率、裂断长均有较大提高，撕裂度有所下降。 - That index of flax tow properties includes the average length, ultra_length rate, disintegration degree, breaking length, short fiber and so on.
麻绒性能指标包括平均长度、超倍长率、分裂度、断裂长度、短绒等。 - If the pulp has high Kappa value, its tensile strength and breaking length are better, but its folder endurance and tearing index are less.
原浆的卡伯值高对保持日本落叶松KP浆的抗张强度和裂断长有利，而对耐折度和撕裂指数不利。 - Breaking length and burst index increased linearly with sulfonate content in the range of 1.1 to 2.3 percent.
磺化度在1.1～2.3%范围内，裂断长、耐破指数随磺化度的增加而线性上升。 - Moreover, the tensile strength index, breaking length, folding endurance and burst index of AS-AQ pulp were higher than those of KP pulp. However, the tearing index was opposite.
浆的抗张指数、裂断长、耐折度和耐破指数都要好于KP浆，但是在撕裂指数上KP浆要优于ASAQ浆。 - The experimental results indicate that 22.13% increase of breaking length and 13.22% gain of tensile strength can be obtained with a 2% of the anionic starch;
实验结果表明，当添加2%的阴离子淀粉，可使纸张裂断长增加22.13%，抗张强度增加13.22%； - The paper strength was good, breaking length was only 0.8% lower than that of control pulp.
裂断长仅比对照样低0.8%，成纸强度好； - On the basis of tests results and production practices, it studies the influence of cotton quality on the quality of finished paper and finds that there are certain relations between strength of finished paper and cotton fiber's maturing coefficient and breaking length etc.
此外根据试验结果和通过生产实践，研究了棉花品质对成纸质量的影响，发现成纸强度与棉纤维成熟系数、断裂长度等有一定的关系。 - Tensile strength and breaking length of cooked noodle were highly significantly positively correlated with protein content;
熟面条的拉断力和拉伸距离与蛋白质含量呈极显著正相关； - Breaking length of drifting sheet ice against conical surface of structures
冰排在锥面上的断裂长度 - For deinking pulp, the breaking length of paper was increased by 20.3% when the dosage was 0.6%.
当用量为0.6%时，废报纸脱墨浆成纸的裂断长提高了20.3%； - When 1% of the product was put into the papermaking system as dry strength agent, the breaking length and burst index were both remarkably improved.
作为纸张增干强剂时发现，当将本品用量为1%加入造纸系统，纸张的裂断长和耐破度均有明显提高。 - Giving a review of related research consequences at abroad and home, an discussion of dynamic ice force dominates the domain, the breaking length is the key to the dynamic ice force research.
通过对课题工程背景的描述和现有相关研究的文献综述，论证了动冰力是当前冰荷载研究的重点，冰排的破碎尺寸是动冰力研究的关键。 - There was a similar trend between breaking length and density of cell walls.
断裂长度和胞壁结构密度与温度的关系相似。 - Under the same beating degree, the burst index and tear index of Alkaline-Oxygen pulp are similar to those of Soda-AQ pulp, but the breaking length of Alkaline-Oxygen pulp is much higher than that of Soda-AQ pulp.
并且在相同的打浆度下，氧碱浆的耐破度和撕裂度同Soda-AQ浆基本相同，但氧碱浆的抗张强度远大于Soad-AQ浆。 - After chemical pretreatment, breaking length of pulp is 4.6 km and burst index is 4.7 kPa · m 2/ g.
预处理后浆裂断长为4.6km，耐破指数为4.7kPa·m2/g，白度31.0%ISO。 - The performance of the sized paper tested were: dry or wet ring crush, tensile strength ( breaking length), surface contact angle.
将表面施胶后的纸样再进行进一步的性能测试：包括干、湿环压强度，抗张强度（裂断长），表面接触角。 - According to national standard and self-assessment test platform, including the arc of the electrode, breaking arc length, slag rate, forming quality, spatter, the electrode melting coefficient of determination and deposition efficiency.
按国家标准和自制试验平台评定焊条的性能，包括焊条的再引弧性，断弧长度，脱渣率，成型质量与飞溅，并测定焊条的熔化系数，熔敷效率。 - Increased glue quantity, the dry and wet ring crush index, breaking length and water resistance of corrugated paper has advanced first and then decreased, so the dosage of sizing agent is not the higher the better.
随着施胶量的增加，纸张的干、湿环压指数、裂断长和抗水性能先提高后降低。